The engine must be in the stock forward location and in the centerline of the car without altering the frame. The engine must be the same manufacturer as the frame and body (GM frame, GM body, GM engine, etc.). Wheel base must be within 1 inch variation right to left side (strictly enforced).Ī chain or eye front and back of car for lift and towing recommended. Minimum of 2” x 3” 0.120” steel tubing recommended. Must retain the original suspension that came with that car. No newer Mustangs permitted.Īll unibody cars must have sub frames tied together. 104" wheel base on the 1984 to 1988 T-Birds and Cougars only. Reinforcing the frame, such as boxing or adding an "X" brace is recommended.įords may run a min. Frames over 108" wheel base may only be shortened in the straight, middle section to achieve 108" wheel base. Pick-up trucks must have lexan rear window or tin cover over truck box.Ĭars must be a min. Or if using a Lexan front windshield, Mount with 3/16 rivots spaced maximum of 6 inche spacing between rivots. Outside, four stong tabs if using a glass windshield. The Earnhardt bar or strap on the outside acceptable.
#Play the sims 1 online full
Any discrepancies see tech man.Īll glass must be removed, except the following: A full windshield with two straps or tubes inside.
#Play the sims 1 online driver
Behind driver may be removed and tinned over with a min. Passenger side of transmission hump may be removed and retinned with a min 22 gauge sheet metal. Stock front firewall and floor must be retained to behind driver. Toe hook or solid linkage recommened.ĭriver's compartment must be sealed off with minimum 22 ga. Gas pedal may be modified or aftermarket. Rear view mirror and a left side mirror that doesn't exceed body line allowed. All sharp objects must be removed or folded over. The interior of the car must be stripped of all flammable material. Must be bolted to the trunk lid and can not extend beyond the width of the fender. Fender well edges must be rolled under, not out. Wheel wells may be radiused for tire clearance. Minimum 3" x 36" yellow strip on back of trunk lid or on rear bumper for all rookie drivers. Bumpers must be strapped to fenders on all four corners to prevent hooking. Hoods can not be bolted shut.Īll cars must have front and rear bumpers. Straps connecting pins to the hood or body recommended. Holes around hood pins must not exceed 5/8". of two but four hood pins recommended in the front to hold it down.
sheet metal may be used for repairs, no aluminum. Any damaged panels must be replaced before the next race day. Only the movement of the wheel openings may be moved to fit the wheel base of the chassis being used.Īny stock appearing nose and tail pieces allowed.īodies must be complete and remain stock appearing. No distortion of the body is permitted to fit the chassis. of 1" from the stock body mounts tolerated.Īny steel body may be run over any chassis of same make. No excessive rear movement of the stock body permitted. No four wheel independent suspensions permitted. 1982 and newer Camaros or Firebirds not permitted.ħ0-81 Camaro and Firebird allowed with stock front clip, unibody and rear suspension and body complete only. No station wagons, convertibles, or Corvettes. ChassisĪny North American built, stock production passenger car, or pick-up truck. Any questions on parts need to be directed to the board of directors. This also includes replacement parts by part number. When the word "stock" is used it means as it came from the factory for the particular year and model in question. Refer to the Safety Rules for the basic building rules (Roll Cage, Bumpers, Fuel Cell, and Approved Clothing etc.)Īll Cars must be stock in every aspect with the following exceptions.
0 kommentar(er)
